Pre-fit before painting. Install new, unpainted parts according to these instructions. Then remove parts, paint them and re-install. Painted or Altered Parts are Non-Refundable. The exhaust system must be installed before the side skirts. Do not tighten exhaust clamps or bracket until installation is complete. The entire Sniper side skirt kit must be installed before exhaust tip installation. The surface temperature where the 2-sided tape is applied must be 75o or above. This temperature must be maintained for 24 hours without moving vehicle or the 2-sided tape will fail.
(more…)

• 0 Comments

Detailed Instructions
1 Check off all items against Snorkel Kit List.
2 Remove guard liner, front rubber and windscreen washer reservoir.
3 Tape Template together accurately on gridline 17. Cut down grid line 28 to mark.
4 Place the Airflow Template supplied on the guard, ensuring the guard crease line are followed exactly. The top guard edge line is a guide only as it will vary slightly between pre and post 1997 cherokee’s.
5 Tape over the sites of all hole points to protect the guard. Locate holes as indicated and mark with centre punch. Drill the 8mm holes. Be careful of any wires or other obstructions under the inner guard.
(more…)

• 0 Comments