Installation Procedure:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air cleaner
3. Using 1/2” socket, remove (3) 5/16’ bolts.
* Please Note: Some units have bolts that are drilled and tapped for air cleaner mounting studs.
4. It is not necessary to remove the fuel lines.
5. Remove fuel line bracket from transmission. (Located on drivers side of bell housing)
(more…)

• 0 Comments

Installation Instructions Procedures:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air intake assembly.
3. Remove throttle body intake box and save bolts.
4. Remove (3) bolts from throttle body.
5. Remove bolts from throttle linkage bracket and save.
6. Install power plate using (3) 6mm x 60 bolts and (3) 6mm flat washers. (Ref. “A”)
(more…)

• 0 Comments

Installation Procedure for this body spacer:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body air intake assembly.
3. Remove (2) nuts from the throttle body and (2) studs from manifold. (Ref. “C”)
4. Remove gasket and clean surfaces.
(more…)

• 0 Comments

Included with your Poweraid Spacer is a sticker with a California Air Resources Board (C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of the engine compartment. Failure to do so may prevent you from passing a smog inspection.
Installation Procedure:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air cleaner assembly.
3. Using 1/2” socket, remove (4) 5/16” bolts attaching throttle body to manifold.
4. Lift throttle body.
(more…)

• 0 Comments

Step of the Installation Instructions:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen the hose clamp and remove the air tube from the throttle body air box.
3. Disconnect the air temperature sensor connector attached to the air box.
4. Loosen the two bolts that secure the air box using a 10mm socket.
5. Remove the oil filler cap (for clearance if needed) and carefully pull and remove the air box. * Be careful not to drop anything in the oil filler pipe.
(more…)

• 0 Comments

The installation instructions step:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air cleaner housing from throttle body.
3. Remove 5/16” bolt (Ref. “C”) & stud (Ref. “D”) from throttle body.
4. Remove (2) 6mm bolts from throttle linkage bracket and save.
5. Move the throttle body forward then remove the gasket and clean the surfaces.
(more…)

• 0 Comments

Installation Instructions. Read Me! Rv. 01/04
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body air intake system.
3. Remove (3) nuts & studs from the throttle body & manifold. (Ref. “C”)
4. Remove support bracket from engine block to throttle body. (Ref. “D”)
* Please Note: When removing support bracket bolt at engine block, loosen bolt enough to remove bracket. DO NOT REMOVE BOLT.
(more…)

• 0 Comments