Conventional Suspension Exploded View Of Rear Suspension Assembly. 2WD Legacy. Performing the following procedure.
1. Remove rear seat cushion and backrest.
2. Raise and support vehicle.
3. Remove rear wheels.
4. Disconnect brake hose from brake caliper.
5. Remove lower and upper strut mount retaining bolts, then the strut assembly.
(more…)

• 0 Comments

Original Exhaust System Removal
Note: With a used vehicle, we suggest a penetrating spray lubricant to be applied liberally to all exhaust fasteners and allowing a significant period of time for the chemical to lubricate the threads before attempting to disassemble.
1. On each exhaust pipe behind the catalytic converter, unbolt the clamp (figure 1) using a 15mm socket. Unbend the metal tab (figure 2) on each pipe.
2. Remove (4) cross-brace support bolts using 15mm socket (figure 3). Place hardware to the side.
3. Lubricate all the hangers and rubber isolators.
4. Using a muffler stand or an additional person to hold the rear muffler into position, remove the hangers from the rubber isolators (figure 3) and at each rear muffler.
(more…)

• 0 Comments

With a used vehicle, we suggest a penetrating spray lubricant to be applied liberally to all exhaust fasteners and allowing a significant period of time for the chemical to lubricate the threads before attempting to disassemble.
1. Carefully disconnect and remove the oxygen sensors located just behind each front flange as the left side shown in figure 1. Place them to the side for use during the installation of your new exhaust system.
2. Unbolt and remove the center support bar shown in figure 2. Place the hardware to the side for use during the installation of your new exhaust system.
(more…)

• 0 Comments

Precision manufactured using aircraft quality T-304 stainless steel; this system is designed to endure years of heavy use. Installing a Borla Performance Exhaust System on your vehicle will eliminate the restrictive design of the stock exhaust, allowing your engine to discharge exhaust gas easier. The result is more horsepower and torque, longer engine life, and a distinctive throaty growl- all this, with easy bolt-on installation. These installation instructions have been written to help you in the installation of your Borla Performance Exhaust System. Please read it completely before installing your system.
(more…)

• 0 Comments

All hardware should be tightened only enough to ensure safety during assembly. Fully tighten all hardware after entire assembly is completed.
1. Insert pairs of 5/8 inch x 7 1/2 inch and 5/8 inch x 8 inch hex bolts through holes in four 1/2 inch thick top bars from the kit. Place the 7 1/2 inch bolt/bar assemblies over the side rails of the vehicle ahead of the cab mount structure. Place the 8 inch bolt/bar assemblies over the side rails behind the cab mount structure.
(more…)

• 0 Comments