The mounting procedure outlined below covers the 1997-2002 Jeep Wrangler. Note that a
Front Gross Axle Rating (FGAWR) of 2500 lbs. is required. A suspension upgrade and additional
ballast may be necessary. You will need to refer to the illustrations and familiarize yourself with each
of the undercarriage components and their relative position to each other. Then proceed as follows:
Begin by removing the four screws that hold the plastic “Jeep” valance in place above the
bumper. Keep these screws as they will need to be reinstalled.
(more…)

• 0 Comments

The mounting procedure outlined below covers CHEVROLET (1988 – 2000), and 1 ton trucks. You will need to refer to the illustrations and familiarize yourself with each of the undercarriage components and their relative position to each other. Then proceed as follows:
1. Position the PUSH BEAM SUPPORT PLATES (Ref. 62A and 62B, Fig. 1) to the front frame rails of the truck. If the truck is equipped with tow hooks, remove the tow hook bolts, and tow hook before installing the PUSH BEAM SUPORT PALTES. Using M14 x 2.00 Hex Head Bolts and M14 Lock Washers provided, bolt the PUSH BEAM SUPPORT PLATES through the outside of the frame. Next use ―” – 13 x 1- ―” Hex Head Bolts, ―” Flat Washers, and ―” – 13 Hex Head Self Locking Nuts to bolt the PUSH BEAM SUPPORT PLATES through the bottom of the frame. Tow hooks may be relocated under the PUSH BEAM SUPPORT PLATES and reattached. Fasteners should only be finger tight.
(more…)

• 0 Comments

The mounting procedure outlined below covers the 2003 and Newer ū & 1 Ton Dodge trucks. You will need to refer to the illustrations and familiarize yourself with each of the undercarriage components and their relative position to each other. Then proceed as follows:
1. Remove the mounting hardware connecting the bumper to the driver side of the frame. Align the two vertical holes on Push Beam Support Plate (62B) with the bumper mounting holes on the outside of the frame. Attach Push Beam Support Plate (62B) to the frame using ―”-13 x 4-―” Hex Head Bolt (G) and ―”-13 Lock Nut (B). The rear and bottom mounting holes on Push Beam Support Plate (62B) must be drilled in the truck frame. With Push Beam Support Plate (62B) in place, drill two 9/16” diameter holes in the truck frame. Drill the hole in the side of Push Beam Support Plate (62B) through both walls of the frame. Drill the bottom hole through the bottom frame wall only. Repeat the process on the passenger side.
(more…)

• 0 Comments

The mounting procedure outlined below covers the 2000 – 2004 Dodge Dakota trucks. You will need to refer to the illustrations and familiarize yourself with each of the undercarriage components and their relative position to each other. Then proceed as follows:
1. Disconnect fog lamps from bumper if equipped on vehicle.
2. Cut rubber portion of air deflector attached to bumper and discard. Open vehicle hood and remove four vertical bumper bolts from existing Bumper Brackets (BB). Remove bolts from two outer bumper brackets if equipped on vehicle. Remove bumper.
3. Clamp existing Bumper Bracket (BB) to frame rail. Remove two existing Nuts (AA) from Bumper Bracket (BB). Use chisel and hammer between head of existing Bolts (CC) and Bumper Bracket (BB) to force them loose. Use caution to prevent damage to parts. Unclamp and remove Bumper Bracket (BB). Repeat process on opposite side of vehicle.
(more…)

• 0 Comments