OPERATING THE V-FORCE AND TESTING THE INSTALLATION
Reconnect the negative battery cable that you removed during the first part of the installation. Make sure the ON/OFF switch on the V-Force is in the OFF position. This is turned to the left. Start the vehicle, turn the V-Force ON/Off switch to the ON position. This is turned to the right. If the V-Force is operating, the LED lights on the front panel will illuminate. NOTE: Not all the LED lights will be illuminated at an idle, just a few of them. As you accelerate the vehicle, more LED lights will illuminate, indicating that the V-Force is functional.
TIP: Don’t turn the V-Force off and on while driving. By doing this you are modifying the input signals to the computer and it may cause a trouble code to set in the computers memory.
(more…)

• 0 Comments

This is installation instructions for BMW F800 from Powercommander. The ignition MUST be turned OFF before installation! 1 Remove the following: -Seat -Upper side fairings -Middle cover -Battery -Airbox -Lower fairings on ST model 2 Unplug the stock wiring harness from each injector. 3 Lay the PCIII near the fuel pump (under seat) temporarily. 4 Route the PCIII harness along the right hand side of the bike and go towards the throttle bodies. 5 Plug the PCIII harness in-line of the stock wiring harness and injectors. 6 Unplug the stock wiring harness from the Throttle Position Sensor (Fig. D). This connector is located on the right hand side of the throttle body. 7 Plug the PCIII harness in-line of (more…)

• 0 Comments

The GROM AUX adapter – an integration between an MP3 player and a factory installed car stereo. Equipped with the specific vehicle harness and standard 3.5mm jack the GROM-AUX interface will allow you to connect your MP3/DVD/XM player or iPod / iPhone to the car stereo system easily.

Proper mounting location
Securely install the interface in a location that is free from heat, humidity, moving parts, or direct sunlight. Beware of hot airflow from your vehicle’s climate control system. We recommend securing the interface to a suitable location, free of sharp metal edges, using double-sided tape, Velcro, or wire ties.
(more…)

• 0 Comments

Installation Procedure:
1. On left wall of trunk, remove the three fasteners that secure the trunk liner.
2. Remove Velcro attached net storage if equipped.
3. Open left rear passenger door fold down seat and remove two remaining fasteners that secure trunk liner.
4. Remove trunk liner.
5. Using Router Docking Station as a template, drill or punch four 1/8” diameter holes in level area near rear of trunk liner. Use caution-insulation located behind this area can bind in drill bit.
6. Attach docking station using four supplied nylon Key Hole clips.
(more…)

• 0 Comments

Module Installation
1. The Edge EZ Module can mount on the flat black plastic fuse box cover located on the driver’s side fender. Adhere the module using the supplied velcro, allowing enough harness movement for removal of the cover. Data Link Connection
2. The Data Link connector is located in different locations based on the
year of the truck:
• 98.5-99 the triangle shaped connector is located on the drivers side of the engine in the wiring harness near the power steering pump
• 2000-2001 the three prong flat connector is located on top of the fuel lift pump that is located on the driver’s side of the engine directly below the MAP sensor, note: on some 2001 truck’s the connector is located on the drivers side of the engine in the wiring harness near the power steering pump
3. A plug is installed in the data link connector on the truck to resist corrosion, remove this and install the supplied connector.
(more…)

• 0 Comments