INSTALLATION
1. Remove the four screws mounting the hood release under the dash.
2. Move hood release assembly 3/4” toward the passenger side of the vehicle and re-mount using the three #10 self-tapping screws provided. Note: The larger hole in the dash mount will not be reused. (Fig. 2)
3. Place the supplied dash bracket between the hood latch and the emergency brake release. Bend the dash bracket so it is parallel to the firewall (Fig. 2). The amount of bend may vary. Note: to protect the finish, place the bracket between two small blocks of wood in a vice and tap down with a soft face hammer or lift with non-marring tool.
(more…)

• 0 Comments

Prepare to Install Kit
1. Front axle
a. If equipped, remove two caps (4) from front wheels (5).
b. Loosen eight lug nuts (6) each from two front wheels (5).
c. Using a hydraulic jack, slowly lift front axle (7) so that two front tires (8) are three to five inches off of ground. Position jack stands under frame (9). Lower frame onto jack stands. DO NOT remove hydraulic jack and maintain some hydraulic jack pressure on axle.
d. Remove eight lug nuts (6) each and two front wheels (5) from axle (7)
(more…)

• 0 Comments

Trail Master recommends this system be installed by a certified technician! These instructions address installation of the Trail Master system and may not include OE recommended procedures for disassembly / reassembly of OE components. Research the areas requiring certification. In addition to these instructions, professional knowledge of disassembly / reassembly procedures as well as post installation checks are required. Attempts to install this system without knowledge and expertise may jeopardize the integrity and or operating safety of the vehicle.
(more…)

• 0 Comments