The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by “do-it-yourselfers.”
1. Allow the engine and all cooling system components to cool down.
2. Place a clean drain pan under the radiator drain plug, then remove the drain plug from the bottom of the radiator to drain the coolant. Remove the radiator cap to increase the flow.
(more…)

• 0 Comments

Vehicle Disassembly for this Toyota Prius.
(a) Lift up the luggage center box cover (rear floor board no. 2). (Fig. 1-1)
(1) Cover the rear trunk edge and bumper with blanket before starting.
(2) Release the lock mechanism from the lock to the unlock position.
(b) Lift up the center luggage box (deck floor box rear). (Fig. 1-2)
(c) Remove the right (passenger) side battery cover (rear floor board no. 3) including the vertical trim cover by separating the four (4) claw fittings. (Fig. 1-3)
(d) Remove the negative battery cable of the auxiliary battery. (Fig. 1-4)
(1) Do not touch the positive terminal with any tool when removing the cable.
(e) Remove the glove box under cover. (Fig. 1-5)
(f) Remove the center cluster under cover. (Fig. 1-6)
(more…)

• 0 Comments

Section 1: Repair instructions for E36 1. Connect DIS/MoDiC 3 tester to a vehicle and read out SRS module fault code memory. If the above mentioned SRS faults are set in the airbag control module, proceed with the repair. 2. Remove corresponding front seat. For a removal instructions refer to RA 52 10 000 , or RA 52 10 001 (sports seat) which can be found in the Technical Information System (TIS). 3. Disconnect vehicle’s battery. 4. Remove cable securing wire ties (1), unplug the belt tensioner connector (2) from the belt buckle assembly and from the (more…)

• 0 Comments