Rosen Multi-Media systems are the easiest-to-install OEM Radio replacement systems available today. However, we strongly recommend reading this guide before starting the installation! Make sure you have the tools you will need. These common items are needed to complete this installation:
· Digital multi-meter (DMM)
· #2 Phillips screwdriver
· Panel removing tools
· 1/4” drive sockets are often needed for dashboard and trim disassembly
· Torx or Allen-drive wrenches if they are used on any panels you will be removing
· A DVD or CD in good condition for testing the system
(more…)

• 0 Comments

Section 1: Repair instructions for E36 1. Connect DIS/MoDiC 3 tester to a vehicle and read out SRS module fault code memory. If the above mentioned SRS faults are set in the airbag control module, proceed with the repair. 2. Remove corresponding front seat. For a removal instructions refer to RA 52 10 000 , or RA 52 10 001 (sports seat) which can be found in the Technical Information System (TIS). 3. Disconnect vehicle’s battery. 4. Remove cable securing wire ties (1), unplug the belt tensioner connector (2) from the belt buckle assembly and from the (more…)

• 0 Comments

Subwoofer Installation 1. Find the fuse block under the hood and open the fuse box cover.
2. Using a 13mm socket and ratchet loosen and remove the fuse box power supply nut.
3. Connect the ring terminal of the power harness to the fuse box power lug and retighten the nut.
4. Route the wire toward the rubber grommet in the fire wall where the hood release cable passes through securing with wire ties where needed.
(more…)

• 0 Comments

The GROM AUX adapter – an integration between an MP3 player and a factory installed car stereo. Equipped with the specific vehicle harness and standard 3.5mm jack the GROM-AUX interface will allow you to connect your MP3/DVD/XM player or iPod / iPhone to the car stereo system easily.

Proper mounting location
Securely install the interface in a location that is free from heat, humidity, moving parts, or direct sunlight. Beware of hot airflow from your vehicle’s climate control system. We recommend securing the interface to a suitable location, free of sharp metal edges, using double-sided tape, Velcro, or wire ties.
(more…)

• 0 Comments

GUARDIAN MODULE – Remove drivers seat and step-well trim for access. Guardian module should be mounted inside seat pedestal. It can be secured using self-tapping screws or wire ties. Do not secure the module until all harnesses are installed and proper lift operation has been verified.

LED DISPLAY PANEL – This harness can be identified by the blue tape near the 6-pin connector. Locate a suitable position on the dashboard within clear view of the driver for the mounting of the LED Display Panel. LED display harness will be routed under step-well trim (See Fig 2). Drill a ū” hole in the dashboard where you wish the center of the display to be. Snap the blue taped end of the LED display harness into the Guardian Module in the connector labeled in blue “Display”. Run the other end of the harness under the step-well and dash area then through the ū” hole. Snap the other end of the LED display harness into the LED Display Panel. Ensure panel is level, and secure using the supplied screws.
(more…)

• 0 Comments

The GROM iPod adapter is designed to provide endless hours of listening pleasure through most vehicles factory radio. To insure that your iPod performs correctly in your car or truck, we recommend that you read this entire manual before attempting install the GROM interface.

Proper mounting location
Securely install the interface in a location free from; heat, humidity, moving parts or direct sunlight. Beware of hot-air flow from your vehicle’s climate control system. We recommend securing the interface to a suitable location, free of sharp metal edges, using double sided tape, Velcro or wire ties.
(more…)

• 0 Comments