Thank you for purchasing the iSimple® Media Gateway. The Media Gateway is designed to provide endless hours of listening pleasure from your factory radio. To ensure that your iPod performs correctly with your radio, we recommend that you read this entire manual before attempting installation of the Media Gateway.
The Media Gateway allows connectivity for iPod, Sirius Satellite Radio tuner (SCC1 sold seperately) and the HD Radio tuner (HDRT sold separately), enabling full control of these devices from the factory installed radio. It also retains original system features such as satellite radio and rear seat entertainment (if equipped).
(more…)

• 0 Comments

Prepare for the installation.
• If possible, install the SWI-PS while you are installing the new head unit. Keep in mind you may need to plug in the factory stereo to locate certain wires; therefore do not complete the head unit installation until the SWI-PS is working properly.
• Plan a general installation location for both the SWI-PS plug and the control body. Keep in mind that the supplied wire harness is two feet long, and the 1/8″ plug harness is three feet long.
• Use a multimeter or approved measuring device for checking vehicle circuits.
(more…)

• 0 Comments

d110.e39 for BMW 5 Series, M5 ’97-’03 – Standard Audio
We’re going to proceed as follows:
- Locating the factory amplifier
- Mounting the new amplifier
- Power connections for the new amplifier
- Audio inputs for the new amplifier
- Connecting the new amplifier to the new subwoofer enclosure
- Installing the new subwoofer enclosure
- Tuning/testing the new amplifier
(more…)

• 0 Comments

1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Unclip and remove the radio trim panel including the a/c vent. (Figure A) 3 Remove (4) 10 MM bolts securing the radio. Unplug and remove the radio.
DOUBLE DIN RADIO PROVISION STACKED ISO MOUNT UNITS
*Note: Refer also to the instructions included with the aftermarket radio.
1 Snap the Double DIN Trim plate into the rear of the factory radio trim panel. (Figure A)
DOUBLE DIN RADIO PROVISION STACKED ISO MOUNT UNITS PROVISION
*Note: Refer also to the instructions included with the aftermarket radio.
(more…)

• 0 Comments

1. Disconnect the negative battery terminal to prevent an accidental short circuit.
2. Unclip and remove the center console trim panel. (Figure A)
3. Unclip the center dash trim panel.
4. Remove (4) screws securing the radio. Disconnect and remove the radio.
5. Remove (3) screws securing the radio rear support bracket and remove the bracket.
(more…)

• 0 Comments