2002 chevy trailblazer lt ignition wiring diagram search result
WIRING INFORMATION: 2002 Chevy Trailblazer WIRE WIRE COLOR WIRE LOCATION 12V CONSTANT WIRE RED and RED/WHITE Ignition Harness STARTER WIRE YELLOW Ignition Harness IGNITION WIRE PINK Ignition Harness SECOND IGNITION WIRE WHITE Ignition Harness ACCESSORY WIRE ORANGE Ignition Harness SECOND ACCESSORY WIRE BROWN Ignition Harness KEYSENSE WIRE (-) LT.GREEN Ignition Harness POWER DOOR LOCK On these vehicles, door locks are controlled by a data bus system. This requires interfacing the door locks in several locations (each of the front doors, the rear hatch, and the fuse box under POWER DOOR UNLOCK the rear seat) or using a databus interface module Read the rest of this entry »
1990-1993 Wiring Chart Circuit LG/W GY/W R/W R/Y P/W LB R/Y GY BK/LB, PK/LG BK/Y T/Y Not Used LB/R BK Circuit Function Left Turn Indicator Hi Beam Indicator Coolant Temperature Sender Feed 12V Input1 Check Brake Indicator Feed Low Coolant Indicator Feed 12V Input1 Check Oil Indicator Feed Malfunction Indicator Lamp (MIL) Feed Air Bag Indicator Tachometer Feed Not Used Illumination Feed Ground Pin Number Circuit Not Used R/LG Not Used Not Used Not Used Not Used R/Y W/R BK Y/W LB/R W/LB DG/LG LG/R Circuit Function Not Used Ignition Switch Not Used Not Used Not Used Not Used 12V Input1 Oil Pressure Gauge Feed Ground Fuel Gauge Feed Illumination Feed Right Turn Indicator Fasten Belts Indicator Battery Indicator Feed
Match to same colors as the 1987-1989 harness.
Read the rest of this entry »
1996-1999 Volkswagen Ignition Coil Power Output Stage Checking
10 Jun
Posted by admin as VW/Volkswagen
Volkswagen > A3 Platform > 1993 – 2002 2.0 Liter 4-Cyl. 2V Fuel Injection & Ignition, Engine Code(s): ABA m.y. 1996-1999 28 – Ignition/Glow plug system Ignition coil power output stage, checking Special tools, testers and auxiliary items VAG 1598/18 test box Multimeter (Fluke 83 or equivalent) VAG 1527B voltage tester Connector test kit VW 1594 Wiring diagram Checking voltage supply Disconnect 3-pin connector from ignition coil. Connect multimeter using test leads from VW 1594 to measure voltage at terminals 1 and 3 of connector. Turn on ignition. Measure voltage between terminals 1 and 3. Specification: 9-14.5 volts Turn off ignition. If the specification is not attained: Check wire Read the rest of this entry »
2002-2005 Chevrolet Trailblazer Undercarriage Installation Instructions
16 Jun
Posted by admin as Chevrolet
1. Temporarily remove the grille and permanently remove the airdam. 2. Disconnect the fog lamp wiring if applicable and then remove the plastic bumper cover from the bumper. 3. Remove the bolts that attach the bumper from the end of the frame rails. 4. Install the hanger plates (Ref 7 & 8). Note: On the drivers side make sure not to pinch the power steering hoses and airbag sensor wire. The top plate on the rear of the hanger plate must install above the hoses. Loosely install the u-bolt (Ref 6) with washers (Ref 11) and nuts (Ref 13) thru the top rear plate and use the bumper bolt temporarily to hold the front of the hanger plate in position. Finger tighten the fasteners until all undercarriage parts are in place. 5. Install the pushbeam (Ref 1) square with the bottom of the hanger plates and secure with bolts (Ref 12), Read the rest of this entry »
This manual contains dismantling data for the following vehicles: MODEL YEAR MAKE MODEL VARIANT ENGINE TRANSMISSION 2007 Chevrolet Trailblazer 4×4 4.2L L6 4L60E
Provide additional support when a vehicle is on a hoist in the following ways:
• Before removing parts, support the opposite end. This helps prevent the vehicle from slipping off.
• Before removing major components, chain the vehicle frame to the hoist pads at the same end as the removal. This helps avoid a tip-off. Read the rest of this entry »
The MSD Digital DIS-2 Plus Ignition can be used on 4-cylinder engines equipped with two dual output coils. The DIS-4 Plus Ignition can be used on 4, 6 or 8-cylinder engines equipped with up to four dual output coils. The Ignitions will accept trigger inputs from electronic distributorless type ignition systems.
NOTE: It is recommended that you have the Service Manual and wiring diagram for your vehicle before beginning the installation of the MSD DIS Ignition.
Read the rest of this entry »
BMW Quick Start Installation (for Dual-plugged heads and non-stock ignition advance, models 1981-1995 with factory electronic ignition systems, see the full Installation & Troubleshooting Guide).
1. Open black box (part #1), set dip switches according to sticker (part #10). Apply sticker to top.
2. Attach black box (part #1) to aluminum plate (part #5) with bolts and washers (parts #11).
3. On 1970-78 models, remove mechanical advance unit. For 1979-1980 models, remove bean can.
Read the rest of this entry »
2006 Chevrolet TrailBlazer Radio With Six Disc CD Changer Does Not Recognize Loaded CD
16 Jun
Posted by admin as Chevrolet
Subject: Radio With Six Disc CD Changer Does Not Recognize Loaded CD And Displays An “INITIALIZING” Message, CD Will Not Play, CD Cannot Be Ejected, Or Disc Icon Does Not Illuminate (Reprogram Radio)
Models:
2005-2006 Chevrolet Avalanche, Suburban, Tahoe
2005-2007 Chevrolet Colorado, Express, Silverado Classic, TrailBlazer
2005-2006 GMC Yukon, Yukon XL
2005-2007 GMC Canyon, Envoy, Savana, Sierra Classic
2005-2006 HUMMER H2 with Six Disc CD Changer Equipped Audio System (RPO UC6)
Read the rest of this entry »
WIRING INFORMATION 1989 Nissan 240SX WIRE COLOR LOCATION 12V CONSTANT WIRE WHITE Ignition Harness 12V IGNITION WIRE BLACK/RED Ignition Harness 12V ACCESSORY WIRE BLUE Ignition Harness STARTER WIRE BLACK/YELLOW Ignition Harness SECOND STARTER WIRE BLACK/WHITE Ignition Harness PARKING LIGHTS (+) RED/BLUE Back Of Dash Dimmer Switch Or Harness In Driver’s Kick Panel POWER DOOR LOCK (Interrupt wire using a ORANGE BLACK Harness In Drivers Kick Panel Or Harness relay) Coming Into Vehicle From Driver’s Door POWER DOOR UNLOCK (Negative trigger) Same wire as lock Harness In Drivers Kick Panel Or Harness Coming Into Vehicle From Driver’s Door
Read the rest of this entry »
Audi, Seat, Skoda and Volkswagen Ignition (transponder) Key Re-programming
19 May
Posted by admin as Audi, VW/Volkswagen
This procedure is required if keys are lost, a replacement Engine Management ECM is fitted, new or additional ignition (transponder) keys needs to be matched to the vehicle. When transponder (ignition) keys are matched to the vehicle the key data is stored in the memory of the immobiliser ECU and used to recognise and validate the ignition keys. The matching of ignition (transponder) keys to a particular vehicle requires the use of the following functions: Login ECM and Adaptation. The Login ECM function enables the technician to enter the 5 or 7 digit login code. A valid login code must be entered in order to program new ignition (transponder) keys for all VAG cars. The Adaptation function enables the technician to adapt new and additional ignition (transponder) keys.
Read the rest of this entry »
Categories
Archives
Cars PDF Document is proudly powered by WordPress - BloggingPro theme by: Design Disease