WIRING INFORMATION: 2004 Cadillac SRX WIRE WIRE COLOR WIRE LOCATION 12V CONSTANT WIRE 12V wires at the ignition harness are low current 12V sources that should not be used to drive any high current positive circuits. Must go to the battery for 12V. LT.GREEN Ignition Harness POWER DOOR LOCK (-) RED/BLACK At Door Lock Switch Inside Driver Door POWER DOOR UNLOCK (-) ORANGE/BLACK At Door Lock Switch Inside Driver Door PARKING LIGHTS (+) DO NOT USE PARKING LIGHTS (-) BROWN/WHITE In Brown Plug At Module Under Glove Box LEFT FRONT DOOR TRIGGER (-) TAN At Driver Door Module In Driver Door RIGHT FRONT DOOR TRIGGER (-) LT.GREEN At Module Inside Right Read the rest of this entry »

• 1 Comment

RGB Module Connections & Controls
The NV_RGB_X Video Interface is capable of both single video and dual video modes of operation. For dual video mode, the optional remote control pad is recommended for switching between the video inputs on the module.
Installation With Plug And Play Factory Harness
Read the rest of this entry »

• 0 Comments

These instructions provide information for the installation of the 60510 Fuel Injection Wire Harness Kit. The contents of these instructions are divided into major Sections, as follows:
1.0 Introduction
2.0 About These Instructions
3.0 Tools Needed
4.0 Pre-Installation and Harness Routing Guidelines
5.0 General Installation Instructions
6.0 60510 & 60511 Fuel Injection Harness Kit
7.0 Start Up
8.0 Trouble Shooting Instructions and Trouble Codes
Read the rest of this entry »

• 0 Comments

INSTALLATION
NOTE: You will need a #50 Torx bit for this installation
1. Assemble the harness support rods as shown below using the provided heim joints and nuts. Leave at least ¼” of thread showing on each heim joint to allow for adjustment during installation. Do not fully tighten the nuts at this time. NOTE: One end of each of the support rods has reversed thread.
Read the rest of this entry »

• 0 Comments

1990-1993 Wiring Chart Circuit LG/W GY/W R/W R/Y P/W LB R/Y GY BK/LB, PK/LG BK/Y T/Y Not Used LB/R BK Circuit Function Left Turn Indicator Hi Beam Indicator Coolant Temperature Sender Feed 12V Input1 Check Brake Indicator Feed Low Coolant Indicator Feed 12V Input1 Check Oil Indicator Feed Malfunction Indicator Lamp (MIL) Feed Air Bag Indicator Tachometer Feed Not Used Illumination Feed Ground Pin Number Circuit Not Used R/LG Not Used Not Used Not Used Not Used R/Y W/R BK Y/W LB/R W/LB DG/LG LG/R Circuit Function Not Used Ignition Switch Not Used Not Used Not Used Not Used 12V Input1 Oil Pressure Gauge Feed Ground Fuel Gauge Feed Illumination Feed Right Turn Indicator Fasten Belts Indicator Battery Indicator Feed
Match to same colors as the 1987-1989 harness.
Read the rest of this entry »

• 0 Comments

The GMRC-03 is designed to be used in Cadillac’s that do not have Onstar or amplified systems. It will retain the warning chimes that are lost when the factory radio is removed. The GMRC-03 will also provide a 12 volt switched accessory wire for proper radio operation. *Note: The GMRC-03 can be used in Cadillac’s that come with a factory amplifier; however the factory amplifier must be bypassed and the speaker wires on the GMRC-03 must not be used. Running new wires to the speakers is recommended. If the Cadillac also has Onstar, that feature will be lost.
Read the rest of this entry »

• 0 Comments

Along with the increase of electronic devices used in automobiles, the use of wiring harnesses for power and signal systems on board is growing remarkably. In these circumstances, the electromagnetic interference (EMI) generated by the power system should cause troubles on signal systems and other chassis-mounted electronic devices. Wiring harnesses act as the direct transmission lines of EMI, so the shielding has become an essential element of power wiring harness system. Generally, braided shield cables and shielded connectors have been used as the EMI shielding measures on the wiring harnesses. Such measures, however, resulted in the increase in cost and size of wiring harnesses. This paper describes the development of a low-cost shielded construction for high-voltage wiring harnesses applied in Toyota’s hybrid electric vehicle (HEV), new Prius.
Read the rest of this entry »

• 1 Comment

WIRING INFORMATION 1989 Nissan 240SX WIRE COLOR LOCATION 12V CONSTANT WIRE WHITE Ignition Harness 12V IGNITION WIRE BLACK/RED Ignition Harness 12V ACCESSORY WIRE BLUE Ignition Harness STARTER WIRE BLACK/YELLOW Ignition Harness SECOND STARTER WIRE BLACK/WHITE Ignition Harness PARKING LIGHTS (+) RED/BLUE Back Of Dash Dimmer Switch Or Harness In Driver’s Kick Panel POWER DOOR LOCK (Interrupt wire using a ORANGE BLACK Harness In Drivers Kick Panel Or Harness relay) Coming Into Vehicle From Driver’s Door POWER DOOR UNLOCK (Negative trigger) Same wire as lock Harness In Drivers Kick Panel Or Harness Coming Into Vehicle From Driver’s Door
Read the rest of this entry »

• 0 Comments

WIRING INFORMATION: 2003 Lincoln Aviator WIRE WIRE COLOR WIRE LOCATION 12V CONSTANT WIRE YELLOW Ignition Harness STARTER WIRE DK.GREEN Ignition Harness IGNITION WIRE RED/LT. GREEN Ignition Harness ACCESSORY WIRE GRAY/YELLOW Ignition Harness POWER DOOR LOCK (-) PINK/YELLOW Harness In Driver’s Kick Panel POWER DOOR UNLOCK (-) PINK/LT. GREEN Harness In Driver’s Kick Panel • The factory module that controls the door locks shuts down to conserve power. When installing an aftermarket keyless entry system, hook up dome light supervision and program the aftermarket system for a double-pulse unlock to “wake up” the module and unlock the doors. PARKING LIGHTS (+) BROWN Headlight Switch DOOR TRIGGER (+) BLACK/LT. BLUE Harness In Driver’s Kick Panel or Courtesy Light Under Dash DOME LIGHT SUPERVISION USE DOOR TRIGGER REAR HATCH TRIGGER COMMON WITH DOORS REAR HATCH RELEASE (+) PURPLE/YELLOW OEM Read the rest of this entry »

• 0 Comments

Attached, for your reference, is a list of OEM paint codes for all 2001 – 2002 model year vehicles and 2003 model year Corolla and Matrix vehicles. NOTE: The body color code is on the vehicle Certification Regulation Label, located on the left front door “B” pillar or door rear lower surface. Please contact your local paint representative for the actual paint mixing formulas or if you need help in color matching.
- 2001 – 2002 model year vehicles, all models.
Read the rest of this entry »

• 1 Comment