If your original radio had a braided strap bolted to the rear of the radio.
TIP: Crimp a ring terminal to the new radios ground wire and insert a bolt through both connectors to connect the ring terminal of the braided ground wire to the ring terminal attached to the new radios ground wire.
If your original radio had a plastic connector containing a single wire plugged into the rear of the radio.
TIP: Crimp a male tab spade to the new radios ground wire. Slide it into the female tab spade connector that had originally snapped into the rear of the factory radio.
Read the rest of this entry »

• 0 Comments

1990-1993 Wiring Chart Circuit LG/W GY/W R/W R/Y P/W LB R/Y GY BK/LB, PK/LG BK/Y T/Y Not Used LB/R BK Circuit Function Left Turn Indicator Hi Beam Indicator Coolant Temperature Sender Feed 12V Input1 Check Brake Indicator Feed Low Coolant Indicator Feed 12V Input1 Check Oil Indicator Feed Malfunction Indicator Lamp (MIL) Feed Air Bag Indicator Tachometer Feed Not Used Illumination Feed Ground Pin Number Circuit Not Used R/LG Not Used Not Used Not Used Not Used R/Y W/R BK Y/W LB/R W/LB DG/LG LG/R Circuit Function Not Used Ignition Switch Not Used Not Used Not Used Not Used 12V Input1 Oil Pressure Gauge Feed Ground Fuel Gauge Feed Illumination Feed Right Turn Indicator Fasten Belts Indicator Battery Indicator Feed
Match to same colors as the 1987-1989 harness.
Read the rest of this entry »

• 0 Comments

Supplemental Restraint System SRS (a) Failure to carry out procedures listed below could result in possible deployment of airbag, personal injury, or unnecessary repairs to SRS. (b) Turn the key switch to the LOCK position. (Fig. 1) (c) Remove the key from the ignition switch. (d) Disconnect the negative battery cable. (Fig. 2) (e) Never use a voltmeter to trouble shoot any of Accidentally probing the connectors to the SRS can lead to deployment of the airbag. (Fig 3) (f) SRS wire harness loom/cover is bright yellow in color.
Read the rest of this entry »

• 0 Comments

WIRING INFORMATION: 2004 Cadillac SRX WIRE WIRE COLOR WIRE LOCATION 12V CONSTANT WIRE 12V wires at the ignition harness are low current 12V sources that should not be used to drive any high current positive circuits. Must go to the battery for 12V. LT.GREEN Ignition Harness POWER DOOR LOCK (-) RED/BLACK At Door Lock Switch Inside Driver Door POWER DOOR UNLOCK (-) ORANGE/BLACK At Door Lock Switch Inside Driver Door PARKING LIGHTS (+) DO NOT USE PARKING LIGHTS (-) BROWN/WHITE In Brown Plug At Module Under Glove Box LEFT FRONT DOOR TRIGGER (-) TAN At Driver Door Module In Driver Door RIGHT FRONT DOOR TRIGGER (-) LT.GREEN At Module Inside Right Read the rest of this entry »

• 1 Comment

Installation Instructions for: Part Number 21-472 2002-2004 Subaru Impreza RS 2.5L 2003-2004 Subaru Impreza TS 2.5L 2003-2004 Subaru Outback Sport 2.5L.
The AEM Cold Air System is the result of extensive development on a wide variety of cars.
Each system is engineered for the particular application. The AEM Cold Air System differs from
all others in several ways. We take the inlet air from outside of the engine compartment where
the inlet air is considerably cooler than the hot under hood air. The cooler inlet air temperature
translates to more power during the combustion process because cool air is denser than warm
air. AEM has conducted extensive inlet air temperature studies and we have seen temperature
reductions of up to 50 degrees by pulling air from outside of the engine compartment. The air
mass flow to the engine is increased because of the increased airflow and reduced inlet
temperature, which translates to more power. The AEM Cold Air Systems come with complete
instructions for ease of installation.
Read the rest of this entry »

• 0 Comments

How-To Guide on replacing your spark plugs and spark plug wires on Mazda RX-8 vehicles. RX-8. While changing spark plugs on most vehicles is an easy task for some, there are some vehicles that are just a little different and make you go: umm…. Well, the RX-8 is definitely one of those vehicles! The RX-8 is an amazing car; it has stellar handling, a lightweight chassis, good looks, four doors, and last but not least a Mazda exclusive rotary engine. While there are a few different vehicle layouts, such as: Front wheel drive, rear wheel drive, all wheel drive, front engine, mid engine, rear engine, they all typically utilize a piston driven internal combustion engine. That is where the RX-8 differs. Like its RX-7 predecessors, the Mazda RX-8 employs a unique style of engine called a Rotary, invented by German engineer Felix Wankel in the Read the rest of this entry »

• 0 Comments

This manual concerns about the step for removing and installing the fuel pump for 2004 Audi A4 L4-1.8L Turbo (AMB) vehicle.
Removing And Installing Fuel Pump
CAUTION: To remove the Fuel Pump (FP), the fuel tank may only be filled to a maximum of 3/4. Empty fuel tank if necessary.
Empty fuel tank
Observe safety precautions.
Observe rules for cleanliness.
CAUTION: Observe safety precautions when disconnecting the battery.
Read the rest of this entry »

• 0 Comments

Obviously, your first concern should be safety. Towing has a significant impact on the dynamics, handling, and braking of your vehicle. Therefore, be certain that your vehicle can meet the demands of the towing application you have in mind. Rent or purchase only the highest-quality towing and safety equipment you can find. Reinforced tow hitches designed especially for certain Nissan vehicles* are available from your Nissan dealer. Hitches for the other Nissan models should be bought from and installed by a professional supplier of towing equipment. Finally, it is important to follow the towing capacity limit set for your specific vehicle, and to ensure that your vehicle is in top mechanical condition; especially the tires, brakes, suspension, and engine cooling system. See your owner’s manual for details.
Read the rest of this entry »

• 0 Comments

2003-2004 (KJ) Jeep® Liberty NOTE: This notification applies only to the above vehicles equipped with Remote Keyless Entry (Sales Code GXM) built from April 1, 2003 through December 12, 2003 (MDH 0401XX through 121200).
The rear flip-up window switch on about 120,000 of the above vehicles may be improperly sealed and could allow water to enter into the switch. This can cause the flip-up window to open unintentionally if it is left unlocked. The rear flip-up window switch must be replaced on all affected vehicles.
Read the rest of this entry »

• 0 Comments

This document contains additional instructions specific to the BMW R1200RT. Please see the wiring instructions included with the heated seat(s) wiring kit for wiring detail.
Installation:
Wire the heated seat(s) and heat controller(s) per the wiring diagram included in the heated seat(s) wiring kit. This wiring diagram is also available on our website. Use the photos below to locate the recommended switched relay wire connection point, and proceed to wire the heated seat(s) and controller(s) per the wiring diagram.
Read the rest of this entry »

• 0 Comments