Tests/Procedures: 1. Ground the Violet/Yellow wire (disarm circuit) that goes to either front door and the theft alarm module. Have the keys out of the ignition and all doors closed when grounding the wire. This should disarm the theft alarm system and prevent the theft alarm from arming. 2. Check that the interior lights do not stay on due to the wire being grounded. If they do, the illuminated entry relay will need to be removed or another method of disabling the theft alarm will have to be used. 3. Another method if the theft alarm module is faulty would be to disconnect the module and replace the Powertrain Control Module (PCM) with a new one.
Read the rest of this entry »

• 0 Comments

Machining Instructions:
NOTE: Stand position is determined upon valve length and rocker pivot length. Please refer to the chart below to determine the proper machining dimensions.
1) MEASURE VALVE TIP TO SPRING SEAT DIMENSION (DIM A) AND REFER TO “Z” COORDINATE (DIM B) ON CHART. MILL OEM ROCKER PEDISTALS DOWN FLUSH WITH THE TOP OF THE HEAD BOLT BOSS BETWEEN #1 & 3 INTAKE VALVE. THIS IS YOUR .000” Z HEIGHT. MILL REMAINDER OF ROCKER PEDISTAL TO COORDINATES LISTED UNDER DIM B.
2) SET THE “X” .000” TO THE CENTERLINE OF #3 & 5 EXHAUST VALVES. SET THE “Y” .000” TO THE CENTER OF THE FACTORY 3/8 SHAFT MOUNTING BOLTS ALREADY MACHINED IN THE HEAD.
3) DRILL AND TAP 9/16-12 X .750” DEEP AT “X” AND “Y” COORDINATES LISTED FOR VALVE LENGTH AND ROCKER BODY BEING USED. INSTALL SUPPLIED INSERTS INTO HEAD.
4) ATTACH ROCKER STAND USING SUPPLIED BOLTS AND TORQUE TO 45 FT/LBS.
Read the rest of this entry »

• 0 Comments