Begin by carefully inserting all four (4) of the Audi radio removal tools into the slots on the face of the radio until you hear and feel a slight click. This locks the tool into place. Carefully pull the radio out of its cavity letting the radio rest on the center console. Hint: Place a clean towel under the radio to when resting on the console. This will prevent scratching the center console
Read the rest of this entry »

• 0 Comments

Congratulations on your purchase of the AWE Tuning Front Mount Intercooler for your Audi. Hundreds of hours of design and operational testing were spent to ensure maximum results without compromise. You have truly selected the best performing intercooler kit for the 2.0T engine. While the install is fairly straight forward, please review these instructions carefully before attempting installation. If you do not feel comfortable installing this kit on your own, contact a professional installer in your area.
Read the rest of this entry »

• 0 Comments

This performance kit installation steps on Audi A3: 1. Disconnect the negative terminal from the vehicle battery. 2. Remove the plastic engine cover. (Fig. 1) 3. Unclip & remove the engine breather hose from the intake pipe. (Fig. 2) 4. Remove the small vacuum hose from under the breather hose on the intake pipe. Follow the vacuum hose & remove the hose from the inlet manifold. Blank off the pipe on the manifold using the small rubber cap supplied. (Fig. 3) 5. Remove the small rubber hose from the side of the intake pipe as shown. (Fig. 4) 6. Unclip & remove the auxiliary air pump feed pipe from the air box as shown. (Fig. 5) 7. Unclip & remove the plastic intake pipe from the throttle housing. (Fig. 6) 8. Remove the air box securing bolt & carefully pull the air box assembly out of its mounting grommets. Remove the air box Read the rest of this entry »

• 0 Comments

For cars with a THREADED gear knob (early Audi,VW,Seat to approx 2005) follow the instructions from point 2
For cars with a SLOTTED gearknob (approx 2005 on) follow the instructions from point 8
1. If fitting to an Audi TT, first using a T20 screwdriver, undo all 8 of the T20 screws surrounding the gear stick. Other cars with a screw on gearknob, skip to point 2..then lift the ring away to expose the rubber underneath
2. Unscrew the existing gearknob….and remove the rubber gaitor and aluminium spacer (if applicable) from the gear stick.
Read the rest of this entry »

• 0 Comments

The new Audi A6 – the most progressive vehicle takes the lead Design and performance are the main driving elements on its way to the top position. Furthermore, the new Audi A6 embodies the consequent continuation of the familiar Audi brand values, sports appeal, progressiveness and intrinsic quality, which are evident in the fourth generation of this sporty business limousine.
Read the rest of this entry »

• 0 Comments

Powerchip technology enhances your Audi to its ultimate level, delivering faster, smoother acceleration in all driving conditions. Whether you enjoy a leisurely weekend cruise or a hard racetrack drive – there is no easier and more effective way to release the potential from your S4 4.2 V8.

The following information is an overview of the performance the Powerchip will deliver. If you have any questions, your Power Consultant will assist you as best as possible. We look forward to giving you the best performance possible from your Audi.
Read the rest of this entry »

• 0 Comments

Common Problems
1. I am having trouble connecting with an ‘02 Audi A4.
This vehicle does pose connection issues with most aftermarket tools. Please continue to retry the connection.
2. I am having trouble getting good data rates on a specific controller.
Audi/VW consolidated sensors into groups. Some sensor groups can update at slower rates then others. Typically, this is text-based sensors on non-critical models like Telephone or Climate control. To resolve this select only those sensors that are important to you until you reach a saturation point for the data throughput.
Read the rest of this entry »

• 0 Comments

After car crash and airbag deployment, VW-Audi airbag sensor can by locked (Control unit faulty or deployed) and must be replaced. Even after small accident Airbag sensor will write in internal memory special error message “crash data stored” or “computer fault” and after you need to exchange very expensive sensor to new one. With our VAG Airbag Reset Tool you can reset and repair airbag computer in your office in 1 minute. No need to remove airbag sensor from the car.
Read the rest of this entry »

• 0 Comments

For the process of handling the LEDs while they are supplied with their operating voltage and not covered by their respective filters or diffuser screens, the following instructions must be observed:
1. Repairs and function checks may be carried out with protection glasses only.
The used glass material must have a UV- or sun ray protection filter (e. g. UVEX sportstyle 9186 088).
Read the rest of this entry »

• 0 Comments

Select the Navigation key on the SETTINGS screen 3 Select the Tracking On Off key 4 Select the On key 11 16 How do I adjust the display REVIEW COPY 2005 nav Navigation System OM USA English nna 07 10 04 debbie GPS INFORMATION DISPLAY The following GPS information will be displayed on the screen latitude longitude altitude signal reception and satellite locations 1.
Read the rest of this entry »

• 0 Comments