In most cases, a Disc Read Error is caused by the following:
• Disc was installed in the CD slot or other slot that is not for the map disc (see “Loading the Map Disc” below)
• Disc was installed upside-down (disc needs to properly be installed with the label side facing up)
• Disc may be scratched, dirty or wet (see nav manual on how to clean disc)
• Nav System or air temperature in vehicle may be excessively hot (allow vehicle to cool down)
• Rough road conditions may be causing the disc to read improperly while the vehicle is in motion (problem should go away on smoother roads)
Read the rest of this entry »

• 0 Comments

This manual contains the pre-installation, assembly and installation for dual player headrest video on Toyota Prius 2010.
Pre-installation Precaution
1. Use Seat and Floor Protectors to avoid damage to surfaces.
2. If the vehicle is equipped with an Anti-theft radio, the radio code must be written down prior to disconnecting the battery cable. The code must be re-entered when the negative battery cable is reinstalled. Disconnecting the battery
Figure may cause certain vehicle settings to be lost. Manufacture’s recommendations for the battery B3 removal should be followed. Disconnecting the battery is recommended.
Read the rest of this entry »

• 0 Comments

The GROM AUX adapter – an integration between an MP3 player and a factory installed car stereo. Equipped with the specific vehicle harness and standard 3.5mm jack the GROM-AUX interface will allow you to connect your MP3/DVD/XM player or iPod / iPhone to the car stereo system easily.

Proper mounting location
Securely install the interface in a location that is free from heat, humidity, moving parts, or direct sunlight. Beware of hot airflow from your vehicle’s climate control system. We recommend securing the interface to a suitable location, free of sharp metal edges, using double-sided tape, Velcro, or wire ties.
Read the rest of this entry »

• 0 Comments

After car crash and airbag deployment, VW-Audi airbag sensor can by locked (Control unit faulty or deployed) and must be replaced. Even after small accident Airbag sensor will write in internal memory special error message “crash data stored” or “computer fault” and after you need to exchange very expensive sensor to new one. With our VAG Airbag Reset Tool you can reset and repair airbag computer in your office in 1 minute. No need to remove airbag sensor from the car.
Read the rest of this entry »

• 0 Comments

Entertainment Systems – FLO TV
FLO TV`99 service provides a superior mobile TV experience that is available to over 200 million people in 105 major U.S. markets. Many key transportation corridors will be covered by the FLO TV network and coverage will extend to 95 percent of where these Americans live, work, drive. That means that you can receive 24/7 programming to keep your entire crew entertained, regardless of the trip duration. Even if you`ve got to keep your eyes on the road, you can enjoy listening to 60 Minutes from CBS Mobile or the
Read the rest of this entry »

• 0 Comments

Raise and support vehicle, allowing suspension to hang free.
Remove the wheel.
Disconnect the shock absorber electrical connector.
Support the lower control arm with a jack stand or screw jack in order to relieve the spring load.
Remove the lower shock absorber nut(s) and bolt(s).
Remove the upper mounting nut(s). On some models, the upper shock mounting nuts are located in the trunk behind the trim cover.
Remove the shock from the vehicle. On some models, you may have to compress the shock by hand to remove from the mounting.
Read the rest of this entry »

• 0 Comments

LIGHT DISARM RESISTORS
The resistors are connected into the wiring at each wheel to bypass the original dampening solenoid so that the Road Sensing Suspension will function without giving the driver a suspension error message on the instrument cluster.

INSTALL RESISTORS
Cut the wires leading to the dampening solenoid on the strut/shock. Connect the wires to the ends of the resistor. (This is an in-line resistor so it does not matter which wire goes in or out.) Tape up both ends with suitable electrical tape to prevent both shorts and corrosion. Tie back out of way with a plastic strap.
Read the rest of this entry »

• 0 Comments

Raise and support vehicle, allowing suspension to hang free.
Remove the wheel.
Disconnect the shock absorber electrical connector.
Support the lower control arm with a jack stand or screw jack in order to relieve the spring load.
Remove the lower shock absorber nut(s) and bolt(s).
Remove the upper mounting nut(s). On some models, the upper shock mounting nuts are located in the trunk behind the trim cover.
Remove the shock from the vehicle. On some models, you may have to compress the shock by hand to remove from the mounting.
Read the rest of this entry »

• 0 Comments

Once the Multimedia Interface Novosonic-Intercar Ventura Technology has been installed, please follow these instructions to activate the different external video sources connected to the original touch screen monitor.
In this installation example we have installed a CD Changer, a DVD Player, a Rear View Camera and an Apple iPod.
1.- Press the DISC button to activate the CD Changer which has been previously installed. When pressing the AUDIO button, the screen will display the Audio menu. The touch buttons perform their regular functions, that is, controlling the CD Changer functions.
- Press the CD button to activate the Interface.
- Press the SEEK UP button (▲) to activate VIDEO 1 (the DVD player); the screen will display the picture of the disc loaded in the DVD player.
Read the rest of this entry »

• 3 Comments

This is a performance product which increases horsepower above factory specifications. Additional horsepower creates more stress on your vehicle’s drivetrain components which may result in drivetrain failure. This product is intended for off-road use only. Use at your own risk!
ATTENTION: Please read instructions carefully before installing the programmer into your vehicle; failure to do so may result in damage to your vehicle’s PCM!
Read the rest of this entry »

• 0 Comments