This suspension kit consists of all parts necessary to make a successful installation onto your Vehicle. All parts have been tested thoroughly. Please make sure you take all necessary safety precautions while fitting the kit.
Note: you should first read these instructions carefully and then take all parts out of the box and pre-assemble them as far as possible before fitting them onto your vehicle.
Read the rest of this entry »

• 0 Comments

Testing a Solenoid Valve To test the solenoid valve in an individual strut, perform the following steps: • turn the ignition switch to OFF, • connect a fused jumper wire between a known good ground and the strut solenoid’s terminal in the control unit connector (back-probe connector at the control unit, do not disconnect) • connect a fused jumper wire between a known good ground and the air charge solenoid’s terminal in the control unit connector (back-probe connector at the control unit, do not disconnect), • turn ignition switch to ON.
Read the rest of this entry »

• 0 Comments

Before Installation
1. Disconnect the negative terminal of the battery.
2. Locate the facotry ECU and disconnect the ECU harness connectors. Refer to the ECU location Chart on the back of this manual.
3. Follow the wire diagram for the specific vehicle list on the back of this manual, and connect each harnesses.
4. Inspect all connections and reconnect the ECU harness connector. Reconnect the negative terminal of the battery.
Read the rest of this entry »

• 0 Comments

A unit designed to provide integration of your vehicle’s built in mobile phone capabilities and your Bluetooth® enabled mobile phone. This kit is designed to make Bluetooth available in your car quick and easy! Simply find the phone connector in your car, plug the unit in, plug in the mic if your vehicle doesn’t already have one and your done!
Read the rest of this entry »

• 0 Comments

Module Installation
1. The Edge EZ Module can mount on the flat black plastic fuse box cover located on the driver’s side fender. Adhere the module using the supplied velcro, allowing enough harness movement for removal of the cover. Data Link Connection
2. The Data Link connector is located in different locations based on the
year of the truck:
• 98.5-99 the triangle shaped connector is located on the drivers side of the engine in the wiring harness near the power steering pump
• 2000-2001 the three prong flat connector is located on top of the fuel lift pump that is located on the driver’s side of the engine directly below the MAP sensor, note: on some 2001 truck’s the connector is located on the drivers side of the engine in the wiring harness near the power steering pump
3. A plug is installed in the data link connector on the truck to resist corrosion, remove this and install the supplied connector.
Read the rest of this entry »

• 0 Comments

Removing original inlet hose intact (can be reused)
1. Follow factory service manual for intake manifold removal.
2. Remove original inlet hose.
3. Install PERRIN inlet hose.
4. Re-install intake manifold in reverse order.
5. See instruction on page (2) for hose connections and routing to the PERRIN inlet hose.
Read the rest of this entry »

• 0 Comments

The information contained in this guide has been prepared for use by persons installing two-way radio equipment (transmitters and receivers) in vehicles. It has been prepared in accordance with current engineering principles and generally accepted practices, using the best information available at the time of publication. It is not possible to cover all of the possible installations of two-way radio equipment in this guide. Accordingly, DaimlerChrysler Corporation cannot be held responsible for incidental or consequent damages arising out of the use of the information contained herein. Installations and modifications are solely the customer’s responsibility
Read the rest of this entry »

• 0 Comments