The Pathfinder was first launched in 1987 as a derivative of Nissan’s pickup truck line. Available initially as a two-door, it was joined by a four-door version in 1990, which has been the sole body style since 1991. The original Pathfinder changed very little on the outside during its life, but was treated to a new dash and interior design in 1994. Whereas the first-generation Pathfinder was a body-on-frame design, the all-new 1996 Pathfinder featured unibody construction. In mid-1999, the Pathfinder, designated as a 1999.5 model, was face-lifted and moved upmarket. Nissan slotted its new Frontier pickup-based body-on-frame Xterra into the space in the lineup vacated by the old base model Pathfinder.
Read the rest of this entry »

• 0 Comments

Removal (Frontier, Pathfinder, QX4 & Xterra)
1. Disconnect negative battery cable. Remove the engine undercover. Drain coolant and remove the radiator.
Remove engine cooling fan and water pump pulley. Remove accessory drive belts. Remove spark plugs.
2. Remove distributor protector. Remove A/C compressor drive belt idler bracket. Remove fresh air intake
tube from rocker cover. Remove thermostat housing hose.
3. Rotate crankshaft to set No. 1 cylinder at TDC on compression stroke. See Fig. 1 . Remove crankshaft
pulley bolt and remove crankshaft pulley. Remove front upper and lower timing belt covers. See Fig. 2 .
4. Align punch mark on left camshaft sprocket with punch mark on timing belt upper rear cover. Align
punch mark on crankshaft sprocket with notch on oil pump housing. See Fig. 3 . Install crankshaft pulley
bolt so that crankshaft can be rotated.
Read the rest of this entry »

• 0 Comments

WIRING INFORMATION 1989 Nissan 240SX WIRE COLOR LOCATION 12V CONSTANT WIRE WHITE Ignition Harness 12V IGNITION WIRE BLACK/RED Ignition Harness 12V ACCESSORY WIRE BLUE Ignition Harness STARTER WIRE BLACK/YELLOW Ignition Harness SECOND STARTER WIRE BLACK/WHITE Ignition Harness PARKING LIGHTS (+) RED/BLUE Back Of Dash Dimmer Switch Or Harness In Driver’s Kick Panel POWER DOOR LOCK (Interrupt wire using a ORANGE BLACK Harness In Drivers Kick Panel Or Harness relay) Coming Into Vehicle From Driver’s Door POWER DOOR UNLOCK (Negative trigger) Same wire as lock Harness In Drivers Kick Panel Or Harness Coming Into Vehicle From Driver’s Door
Read the rest of this entry »

• 0 Comments

Obviously, your first concern should be safety. Towing has a significant impact on the dynamics, handling, and braking of your vehicle. Therefore, be certain that your vehicle can meet the demands of the towing application you have in mind. Rent or purchase only the highest-quality towing and safety equipment you can find. Reinforced tow hitches designed especially for certain Nissan vehicles* are available from your Nissan dealer. Hitches for the other Nissan models should be bought from and installed by a professional supplier of towing equipment. Finally, it is important to follow the towing capacity limit set for your specific vehicle, and to ensure that your vehicle is in top mechanical condition; especially the tires, brakes, suspension, and engine cooling system. See your owner’s manual for details.
Read the rest of this entry »

• 0 Comments

The Nissan LEAF five-passenger electric car will be powered by an advanced, lithium-ion battery pack that will provide a drive
range of 100 miles on a full charge, as measured by the LA4 test cycle. AV’s Nissan-branded charging stations will be available
at the sale of each Nissan LEAF as part of the vehicle’s total driving system. The home-charging stations are designed to
provide a safe and reliable charge when installed with a connection to a 220-volt line. It will take eight hours to fully charge the
Nissan LEAF from a fully discharged state.
Read the rest of this entry »

• 0 Comments

1. Peel the protective vinyl coating off of the top and bottom brackets and attach them to the fan shroud with the screws provided as shown.
2. Hold the fan assembly so that it is approximately centered over the radiator core. The long 6mm bolts will be used in the slots of the bottom bracket with the threaded end pointing down. The threaded end of the bolts, with rubber caps placed over the ends, will slide into the holes on the bottom of the radiator. Determine which set of slots you will use by looking at which slots line up over the holes. This fan kit is designed to accomodate both the OEM radiator as well as popular aftermarket radiators. These bolts may go in the inside or outside slots on the bottom brackets depending on which radiator you have. Leave these loose for now – you will need to tighten them after you install the fan assembly.
Read the rest of this entry »

• 0 Comments

Service at the indicated distance or time, whichever comes first. Use this schedule if the vehicle is driven MAINLY in Canada or in any of the following conditions; if only OCCASIONALLY driven in these conditions, use the Normal Conditions schedule.
Severe Driving Conditions
- Less than 5 miles (8 km) per trip or, in freezing temperatures, less than 10 miles (16 km) per trip
- In extremely; hot weather (over 90°F/32°C)
- Extensive idling or long periods of stop-and-go driving
- Trailer towing
- On muddy, dusty, or de-iced roads
Read the rest of this entry »

• 2 Comments

This manual includes information for all options available on this model Therefore you may find some information that does not apply to your vehicle All information specifications and illustrations in this manual are those in effect at the time of printing NISSAN reserves the right to change specifications or design without notice and without obligation IMPORTANT INFORMATION ABOUT THIS MANUAL You will see various symbols in this manual They are used in the following ways WARNING This is used to indicate the presence of a hazard that could cause death or serious personal injury To avoid or reduce the risk the procedures must be followed precisely The inside pages of this manual contain a minimum of 50 recycled fibers including 10 post consumer fibers CALIFORNIA PROPOSITION 65 WARNING WARNING Engine Exhaust some of its constituents and certain vehicle components contain or emit chemicals known to State of California to cause cancer and birth defects or other reproductive harm 2000
Read the rest of this entry »

• 0 Comments

The FP-611 (1998-Newer Ford Taurus base) is a no-holes passenger side base. Installing a no-holes base does not require drilling any holes into the vehicle. Installing the FP-611 Base in the vehicle:
1. Place both front seats of the vehicle in their most rearward position.
Read the rest of this entry »

• 0 Comments

Module Installation
1. The Edge EZ Module can mount on the flat black plastic fuse box cover located on the driver’s side fender. Adhere the module using the supplied velcro, allowing enough harness movement for removal of the cover. Data Link Connection
2. The Data Link connector is located in different locations based on the
year of the truck:
• 98.5-99 the triangle shaped connector is located on the drivers side of the engine in the wiring harness near the power steering pump
• 2000-2001 the three prong flat connector is located on top of the fuel lift pump that is located on the driver’s side of the engine directly below the MAP sensor, note: on some 2001 truck’s the connector is located on the drivers side of the engine in the wiring harness near the power steering pump
3. A plug is installed in the data link connector on the truck to resist corrosion, remove this and install the supplied connector.
Read the rest of this entry »

• 0 Comments