Simple step to light reset service for Renault Laguna. The reset button is located under the speedometer on the instrument cluster.
Switch ignition on.
Switch ignition on.
Press reset button until “spanner” symbol flashes.
Keep button depressed until “spanner” symbol stops flashing and remains
illuminated.
Read the rest of this entry »

• 0 Comments

The lamp illustrated is an oil level low warning indicator and not a service interval indicator. When the engine oil is at the correct level, this lamp will automatically extinguish. Malfunction Indicator Lamp (MIL) The lamps illustrated above, are Malfunction Indicator Lamps (MIL) and not service interval indicators. When illuminated there is a problem with the vehicle. Refer to manufacturer’s documentation for further information.
Read the rest of this entry »

• 0 Comments

The information below documents the procedure I used to install the Hella Micro DE fog lamps on Saab 92-X.
Disclaimer: This information is provided as a reference and the author assumes no responsibility for any damage that may result from this modification to your car.
1. Prep: I started by purchasing the stock Subaru Fog Lamp Relay and Fog Lamp Switch. Since the car is pre-wired for the factory fog lamps, this allows you to use the existing wiring for the installation of the Hella fog lamps.
The part numbers for the parts are: The Fog Lamp Relay is B48 in the diagram below and is the 3rd relay from the bottom. The location will be the only one empty. The Fog Lamp switch is connected to B160, which will be right behind the switch location. By removing the change holder, I was able to install the relay and switch, and plug the connector into the back of the switch without removing the lower dash panel, but it requires some patience.
Read the rest of this entry »

• 0 Comments

R ENAULT IS PROMISING SOMETHING FOR .everyone with its new-for-2000 Cl i o .Collections, which offer 10 different trim levels across three model ranges. In a nutshell, the Freeway Collection (Liberté, Grande, MTV) offers models at affordable prices for first-time and young buyers or those looking for a second car, while Elegance (Alizé, Etoile, Initiale) is aimed at buyers seeking more luxury in a small car. The Sport Collection (Sport, Si, RSi and Renaultsport 172) speaks for itself, but offers the widest-ever range of sporting Clios, with performance from warm to scalding.
Read the rest of this entry »

• 0 Comments

This Service & Airbag Reset Tool allows you to reset your car’s Airbag Fault Light & Service (Oil Service & Inspection Service) Indicators on VW/Audi/Seat/Skoda manufactured from 1994 to the latest one that using CAN-BUS protocol, please read the Compatible Vehicles for detail models.
Read the rest of this entry »

• 0 Comments

Alfa Romeo, Fiat and Lancia oil service and oil degradation reset tool. Compatible with the latest Fault Tolerant CAN vehicles. Designed to extinguish the oil service light and to show if there is a fault on the CAN bus which is a common problem with some vehicles.

▪ Compatible with latest Fault Tolerant CAN vehicles.
▪ Also compatible with Alfa Romeo Mito, Fiat Punto 05 , Grand Punto & 500.
▪ CAN BUS Fault indicator.
Read the rest of this entry »

• 0 Comments

On a vehicle with IR system the immobilizer (decoder) and remote-key (PLIP) are dependant of each other (exept later IR
systems with KRS). This means that the remote in addition to controlling doors it also verifies the key and opens the
immobilizer to allow the vehicle to start.
On a vehicle with IR or RF system with KRS, the remote-key (PLIP) and immobilizer are independent systems where the
immobilizer is controlled by a small Transponder Chip inside the key head and an antenna ring around the ignition that
checks the Transponder Chip when the key is in the ignition and turned on. The IR or RF part is only for remote
controlling the doors wich means that synchronized keys (working PLIP) will not solve any non starting problems due to
blocked immobiliser. The battery inside the key only affects the PLIP function as the KRS is not dependant of batteries.
The KRS type (on IR keys) can be recognized by opening the PLIP and the Transponder Chip is seen as a square black
unit separate from the electronic printboard (PLIP electronics).
Read the rest of this entry »

• 0 Comments

Tools you need: • Torx T-20 • Socket wrench size M10 • Small screwdriver • Chalk or pencil (if you want to put some marks on the bodykit to fix it exactly as it was) • A bucket to store the washer fluid (remember: it might be upto 6.5 liters!) • Old soft blankets, wood blocks or a friend to lend a helping hand to avoid scratches to the bumper paint
Read the rest of this entry »

• 0 Comments

This bulletin supersedes TSB 06-40-005 to include a procedure for GDS. CAUTION: Before replacing a transaxle to improve a shift quality condition, follow this procedure to reset and relearn the adaptive learning.
DESCRIPTION: The PCM or TCM contains logic to adjust solenoid duty and line pressure as needed to compensate for normal clutch wear over the life of the transaxle. This bulletin provides the procedures necessary to reset (erase) and “relearn” the PCM/TCM adaptive values. After the following repairs have been completed, the PCM/TCM adaptive values must be reset in order to provide optimum shift quality:
Read the rest of this entry »

• 0 Comments

Nissan has determined that some 2007 model year Armada and Titan vehicles may have been equipped with TPMS sensors designed for the previous model year vehicle. The TPMS is functional and detects low tire pressure as designed. However, in some vehicles, this condition could, at some point, cause the low tire indicator lamp to illuminate even if the tire pressure is not low. The TPMS would continue to operate normally if reset. To correct this potential condition, Nissan will conduct a Voluntary Service Campaign to inspect the valve stem cap to Read the rest of this entry »

• 0 Comments