st499207400 Result Search:
On-Board Programming InstructionsFor BUICK & CADILLAC
Originate New Master Key
1. Insert properly cut key into ignition and turn it to the ON (RUN) position. The security light on the dash will illuminate for 10 minutes.
2. Within one minute of the light going out, turn the ignition cylinder to OFF and then back to
555P Ford-PATS Interface ModuleThe 555P interface module is used when installing remote start products in Ford vehicles equipped with a factory immobilizer. The 555P allows for easy interfacing between the remote start and the factory immobilizer, while maintaining the integrity of the OEM system.
An immobilizer is a transponder-based anti-theft system. It uses a
03-06 Nissan 350Z 3.5L Bassani Exhaust Installation InstructionsInstallation instructions on Nissan 350z5:
1. Raise and support vehicle.
2. Lubricate stock rubber hangers with penetrating oil.
3. Remove electrical ground strap from muffler.
4. Remove fasteners attaching stock Y-pipe inlet flanges to mating flanges on converter outlet pipes.
5. Remove fasteners attaching Y-pipe outlet flange to mating flange on exhaust mid-pipe. Remove Y-pipe
Torsen 8.8 Inch 28 Tooth Differential into Live Axle Rear Suspension Installation Instructions(Applications – Ford Mustang, Crown Victoria, Ranger, F-150, and Explorer)
NOTE: Be sure to keep right and left bearing cups, shims, and bearing journal caps separated!
1. Install ring gear on Torsen differential. Torque bolts as specified in the Ford Service Manual.
2. Install two new journal bearings on Torsen differential.
3. Mount differential
Zach’s Explorer Sub Box DesignPart Contents: Hi! I’m Zach Telford, and you’ve downloaded my subwoofer box plans for 1 and 2nd Gen. Ford Explorers and Mercury Mountaineers. As a forewarning, this design has only been tested on a 2nd Gen. Ford Explorer XLT. Ok, now a little bit of background. I’m a 20-yr-old Russian
Drive Axles General Motors 1214 Ring GearVehicles application: Chevrolet P-30 & GMC P-3500
The axle has a banjo-type housing with a removeable carrier. The drive pinion is straddle mounted on removeable carrier. There is no adjustment for drive pinion depth or bearing preload. The preload on the differential side bearings is set by adjusting nuts on which
Contact{mailform}
1984-1998 Jeep Wagoneer/Commando/Cherokee/ Crankcase Ventilation SystemCrankcase emission control equipment is separated into two different systems: Positive
Crankcase Ventilation (PVC) and Crankcase Ventilation System (CCV). The systems perform
the same function, differing only in the way the exhaust gases are metered. The PVC system uses
a valve, containing spring loaded plunger, which meters the amount of crankcase vapors routed
to
BMW E36 & E46 3 Series Quick Fit & Quick Fit Pro Harnessbelts InstructionsSCHROTH BMW specific asm-Rallye 4 Series harnessbelts are only intended for installation at the left and right outboard front seating positions of designated BMW and MINI model passenger cars which have been specifically evaluated by SCHROTH engineers for anchor point locations and suitability of available front seats. Before attempting installation,
2000 Chevrolet Camaro Transmission Removal & InstallationREMOVAL & INSTALLATION
WARNING: Deactivate air bag system before performing any service operation. See appropriate AIR BAG RESTRAINT SYSTEMS article in ACCESSORIES & EQUIPMENT. Do not apply electrical power to any component on steering column without first deactivating air bag system. Air bag may deploy.
CAUTION: When battery is disconnected, vehicle computer