1990-1993 Wiring Chart Circuit LG/W GY/W R/W R/Y P/W LB R/Y GY BK/LB, PK/LG BK/Y T/Y Not Used LB/R BK Circuit Function Left Turn Indicator Hi Beam Indicator Coolant Temperature Sender Feed 12V Input1 Check Brake Indicator Feed Low Coolant Indicator Feed 12V Input1 Check Oil Indicator Feed Malfunction Indicator Lamp (MIL) Feed Air Bag Indicator Tachometer Feed Not Used Illumination Feed Ground Pin Number Circuit Not Used R/LG Not Used Not Used Not Used Not Used R/Y W/R BK Y/W LB/R W/LB DG/LG LG/R Circuit Function Not Used Ignition Switch Not Used Not Used Not Used Not Used 12V Input1 Oil Pressure Gauge Feed Ground Fuel Gauge Feed Illumination Feed Right Turn Indicator Fasten Belts Indicator Battery Indicator Feed
Match to same colors as the 1987-1989 harness.
Read the rest of this entry »

• 0 Comments

Subject: Noise Coming From Instrument Panel Cluster (Replace Instrument Panel Cluster (IPC)) Attention: Appropriate repair is based on vehicle build date. Use GMVIS to determine the vehicle build date. This bulletin is being revised to add model years and provide important repair information. Please discard Corporate Bulletin Number 04-08-49-015 (Section 08 — Body and Accessories).
Read the rest of this entry »

• 0 Comments

The Instrument Cluster contains sensitive electronic components. Great care should be taken when working around or handling electronic components. Avoid touching components on a circuit board directly. Static shock could damage these components. Avoid working in areas that can create excessive static shock such as carpeted rooms.
1. First disconnect the Negative (-) Battery Terminal and apply the Emergency Brake.
2. Remove the instrument cluster trim by the following steps.
Read the rest of this entry »

• 0 Comments

In 1964, at the World Fair in New York, an attractively designed coupé was launched that was intended to appeal to a wide public and was offered at a reasonable price. This Ford Mustang went like a bomb. In just one year 420,000 were sold and the Mustang made its mark in the annals of the American motor industry. 40 years on the Mustang has finally come back to life. It is as if time has been turned back. With its forceful retro design, this latest Mustang looks much as it did before. It also adheres to the earlier basic concept: a lot of car for a little money. The new Mustang GT, with its long bonnet, prominent front apron, blunt rear and taut coupé-style roof line, is based on the tradition of the American “muscle cars”. Naturally is has an engine to match. Immediately on start up the thrilling voice of the 8-cylinder engine is heard, and the pleasure is compulsive.
Read the rest of this entry »

• 0 Comments

Ford has marked the 45th anniversary of the Mustang with a major redesign not only of the bodylines but also the interior, particularly of the dashboard. The steering, suspension and V8 engine have also been reviewed. The Mustang comes in coupe and convertible models, in a base version with a V6 engine or a GT powered by a V8.
Interior and trunk
Front seat access is relatively easy for a sport coupe. Its very comfortable seats have good side support, fine for anything short of racing the car on a track. The driving position is very good and the driver’s seat is equipped with lumbar adjustment. Legroom is generous, but headroom is a bit tight for tall people.
Read the rest of this entry »

• 0 Comments

This short explanation covers the installation slot-in MAF sensor to inlet tube for Ford Mustang vehicle, following the steps below:
1. Remove the factory harness from the OEM MAF Sensor
2. Remove the two screws and gently slide the MAF out of its housing
3. Your now ready to install your new GMS MAF sensor to your intake tube.
Read the rest of this entry »

• 1 Comment

how to properly determine the main bearing bore diameter on 1993-2002 Ford 2.5L VIN B and KL engines. This engine is made by Mazda and used in the Probe and 626 car models. It appears some previously published information may have been inaccurate. Many service specifications have listed a housing bore diameter .002˝ smaller than it should be.
Read the rest of this entry »

• 0 Comments

In 1993 Chrysler has improved security in their Double-Bitted locking system. All 1993 vehicles will utilize a new key groove (78 primary, 79 vallet), the change in key groove will initiate a keyway restricted vallet system and new J-Series codes. A seventh tumbler has been added to the ignitions.

To continue giving your customers the quality service their use to, the following should be noted when servicing the 1993 vehicles:
• Some new component parts have been added to the line, old component parts remain unchanged. (Tumblers, Caps, Shutters, Springs, Pawls, Shafts)
• New lock service packages will be required for 1993.
Read the rest of this entry »

• 0 Comments

This Borla Performance Rear Section Exhaust System (Part number 11777 & 11778 ) has been designed for 2010 Ford Mustang GT equipped with a 4.6L V-8 engine and automatic or manual transmissions. Borla Performance Industries recommends that an exhaust shop or professional after market parts installer, who has all the necessary equipment, tools and experienced personnel needed for proper installation, should perform the installation of this system. However, if you decide to perform the installation, we recommend someone should help you. Ensure the installer uses all under car safety precautions including eye protection. Please take time to read and understand the following… By installing your Borla Read the rest of this entry »

• 0 Comments

This Borla Performance Rear Section Exhaust System (Part number 11750) has been designed for 2005 Ford Mustang GT equipped with a 4.6L V-8 engine and automatic or manual transmissions. Borla Performance Industries recommends that an exhaust shop or professional after market parts installer, who has all the necessary equipment, tools and experienced personnel needed for proper installation, should perform the installation of this system. However, if you decide to perform the installation, we recommend someone should help you. Ensure the installer uses all under car safety pre- cautions including eye protection.
Read the rest of this entry »

• 0 Comments