The installation of AWE Cold Cone Box for Volksgagen Mk5, CC and Audi A3, TT vehicles:
Step 1: On 2006-08 FSI engines, remove the entire engine cover assembly and inlet ducting. Leave the duct that bolts to the radiator support in place. Remove the MAF sensor from the engine cover assembly. On 2008.5-> TSI engines, remove the factory airbox, intake tubing, and MAF sensor housing. Leave the duct that bolts to the radiator support in place. Remove the MAF sensor from the sensor housing.
Step 2: On vehicles equipped with the 2006-08 FSI engine install the included heat shield above the exhaust manifold by first securing it with a 6mm allen head bolt and washer in the location shown at Arrow A in Figure 1. Installation is done from above. Then install the intake support bracket on top of the heat shield at arrow B in Figure 1 using a 6mm allen head bolt and washer. Position the bracket leg as shown in Figure 2. On vehicles equipped with the 2008.5-> TSI engine install the intake support bracket using one of the included M6 allen head bolts and washer as shown at arrow in Figure 3.
Step 3: Install the MAF sensor into the fitting on the A.W.E. metal intake tube using the included 4mm bolts and washers. Place the washers between the senor and the mounting flange as shown in Fig- ure 4. Make sure the sensor is pointed in the correct direction as shown in Figure 5.
Step 4: Install the metal intake tube with the MAF sensor as shown in Figure 6. Secure it with the t-bolt support bracket installed in Step 2 and attach it to the turbo compressor inlet using the black reducer coupler with a 70-90 and 50-60 hose clamp. On FSI engines, reconnect the MAF electrical harness to the sensor (See page 6 of this document for wiring extension directions for TSI engine). Then install the accordion coupler and secure it to the intake tubing using a 70-90 hose clamp as shown at arrow.

Source

Related Tags: , , , , , , , , , , , , , , , , , , ,